More from the Manufacturer

• Tools
• Equipment
• Glass
• Hanging
• Project
• Industrial
• Garage
• Indoor
• Outdoor
• Mounting
• Storing
• Office
• Restroom
• Smooth Surface
• Painted Surface
• Wall
• Metal
• Closet
• Board
• Home
• School
• Kitchen
• Bathroom

• Heavy Duty
• Peel & Stick

• Water Resistant
• Temperature Resistant
• Humidity Resistant
• Moisture Resistant

Roll

Care and Application:

Instructions:

• Clean and dry surface before application
• Peel tape from fastener and press firmly into place
• Adhesive reaches maximum strength after 24 hours

Note: Not recommended for fabrics, dashboards, flexible vinyl or underwater use. Continued exposure to full sunlight can damage fastener.

Removal Instructions:

• Warm the tape (Hook or Loop) with a hair dryer. (Do not use a heat gun)
• Peel off the tape (Hook or Loop) the adhesive will remain on the substrate
• Warm the adhesive with the hair dryer (again, do not use a heat gun), peel off a piece and roll in a ball
• Cool the adhesive down. This may be done with ice in a plastic bag (only takes a few moments)
• Stick the ball on the adhesive which is on your substrate and pull it off
• Repeat step # 5 until the adhesive is completely removed from the substrate. This may take some time
• If any residue tackiness remains on the substrate you may now use a commercial remover like Goo Gone, acetone, WD-40, mineral spirits or citrus based cleaners

Weight Rating:

1 lbs per square inch up to 10 lbs

Functional Temperature Range:

0-120° F (-18-49° C)